Hi Frank,
I'm a fairly new member here and noticed that you were the proud owner of a Grizzly G0632. I have ordered one myself but they are currently out of stock until around April 1st or so. Have you encountered any problems with the lathe? I noticed that you had to open the end of the bed casting to remove the tailstock or head. Was this very hard to do? I'm still not sure if the bed is cast iron or steel at least not from the messages online that I have seen. I currently have the smaller G0462 and it has been ok to learn on but the reeve drive is noisey and it just too fast for larger turnings. Mine shows that it's slowest speed is 740 rpm. One thing that I changed about it was the toolrest. It was entirely too flimsy for me so I bought one off ebay and it works much better. I can't wait to get the G0632. It may not be a Jet but it sure does fit my pocketbook much better. Take care.
Dennis Stowe